Concentrate Inject Check Valve; Flowmeter; Inject/Bypass Valve - Waterous AQUIS 1.5 Installation, Operation And Maintenance Instructions

Safety Introduction

Concentrate Inject Check Valve

This check valve is installed in the injector fitting and prevents the foam solution
from entering the concentrate hose

Flowmeter

The flowmeter paddlewheels measure the amount of water flowing
The flowmeter is installed in the flowmeter tee or foam manifold.
1
3
1. Flowmeter
Product Overview
(Figure 10). The valve is 3/8 inch NPT.
Figure 10
2. Cable 3. Paddlewheel
Figure 11
Installation Operation

Inject/Bypass Valve

Use the inject/bypass valve
follows:
• Rotate the handle to the inject position to create a foam solution.
• Rotate the handle to the bypass position to direct the concentrate out of the
system.
(Figure 11).
2
|
28 64
Maintenance Troubleshooting
(Figure 12) to manually direct the concentrate as
Figure 12