Main Cam Gear Replacement - Panasonic DVCPRO HD EX AJ-HD1200AP Service Manual

2-10. Main Cam Gear Replacement

(Removal)
1. Remove the Cleaner Solenoid. (Refer to 2-8)
2. Remove the Motor Bracket Unit. (Refer to 2-9)
3. Turn the Cam Relay Gear B counterclockwise to
place the mech. in the loading complete mode.
(Fig.2-10-1)
4. Remove the Loading Guide. (Refer to 2-13)
5. Remove the S Loading Arm Unit. (Refer to 2-13)
6. Remove the S4 Post Base Unit. (Refer to 2-11)
7. Remove the Cut Washer A and the Cam Relay
Gear B. (Fig.2-10-1)
8. Remove the Cut Washer B and the Cam Relay
Gear A.
9. Remove the Cut Washer C and the S Load
Sector Gear Unit.
10. Remove the Cut Washer D and the S Relay Gear.
11. Remove the Cut Washer E and the Main Cam
Gear.
(Installation)
1. Install a new Main Cam Gear in the reverse steps
of the removal.
2. Make sure that the pin of the Mode SW and the
hole of the Main Cam Gear are geared upon
mounting the Motor Bracket.
MECH-33
Fig.2-10-1