Panasonic DVCPRO HD EX AJ-HD1200AP Service Manual page 282

1-18. REV Tape Path Confirmation
and Adjustment
(T6 Post Height)
ADJ.
T6 Post Height
TP
TP4: A PROC Board (Slot 2)
MODE 25M PLAY (+1)
25M REV (-1):
TAPE
VFM3582KM or VFM3582KL
TOOL
VFK1148A (Post Driver)
SPEC. C1 ≥ Cp1 x 0.75
C2 ≥ Cp2 x 0.75
Lower limit at T5 post in REV –1.0 mode.
Tape has no curl and bent at T5 and T6
Post.
<How to place the VTR in the REV -X1>
1) Open the service menu.
2) Press the both "PLAY" and "REW" button
together in the VTR operation mode.
1. Perform 1x and –1x playback alternately. Confirm
the CTL output level is within the specification in
the figure 1-18-1. If it is out of specification, adjust
the T6 Post Height.
2. When adjusting a post, try it by 45 degrees step.
3. Place the unit in the –x1 playback again, and
confirm that the CTL output level (C1/ C2) is more
than 75% of the normal playback (CP1/ CP2).
Also confirm that the limit condition of the P5 and
P6 posts is as shown in figure 1-18-1.
4. If it is out of specification, adjust T6 post height.
"1-2. Post Height Pre-Adjustment".
< Post Limit >
Post
T5
T6
A: UPPER
D: CURL
C1, C2: SHTL x-1
Cp1, Cp2: PLAY x1
1-19. Long PLAY Tape Damage
Confirmation CUE/REV
Damage Confirmation
MODE
Change CUE and REV x-1 mode alternately
TAPE
Long PLAY Tape L-Cassette (Beginning)
(AJ-5P93LP: Recorded Tape)
SPEC.
No damage on the tape at T5 and T6 posts
1. Prepare a 50M recorded tape.
Confirm that there is no tape damage in
intermittent mode and while switching CUE and
REV.
2. If it is out of specification, adjust T5 and T6 posts
height by following the Paragraph "1-2. Post Height
Pre-Adjustment".
Note :
See page MECH-1 for post location.
MECH-12
A B C D
NG NG OK NG
OK OK OK NG
B: FREE C: LOWER
E: BEND F: DROP
Figure 1-18-1
Figure 1-18-2
E F
NG NG
NG NG