Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
HOW TO MAINTAIN THE TRAINING BIKE
Inspect and tighten all parts of the training bike regu-
larly. Replace any worn parts immediately.
To clean the training bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, the drive belt
may need to be adjusted.
See the EXPLODED DRAWING on page 27 to iden-
tify the parts mentioned below.
To adjust the Drive Belt (66), rst press the power
switch to the off position and unplug the power
cord.
Use a at screwdriver and remove the Upper Shield
(10) and the right Shield Cover (13).
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
•• Reorient or relocate the receiving antenna.
•• Increase the separation between the equipment and the receiver.
•• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user’'s authority to operate this equipment.
Next, remove the #8 x 32 x 13mm Screw (88) from the
Right Shield (12). Then, remove the #8 x 3/4" Screw
(94) from the Left Shield (11).
Then, use a socket set to remove the two 1/4" Flange
Nuts (99) from the Right Shield (12).
Remove the two #8 x 1/2" Screws (95) on the right side
of the Electronics Shield (98). Then, gently move the
Right Shield (12) away from the training bike.
Locate the Idler Pulley (37). Loosen the 3/8" Jam Nut
(71). Then, tighten the Idler Adjustment Screw (39)
until the Drive Belt (66) is tight.
When the Drive Belt (66) is tight, tighten the 3/8" Jam
Nut (71).
Reattach the Right Shield (12) with the #8 x 1/2"
Screws (95), the 1/4" Flange Nuts (99), the #8 x 3/4"
Screw (94), and the #8 x 32 x 13mm Screw (88). Then,
reattach the Upper Shield (10).
24
Advertisement
Table of Contents
