Table of Contents
Advertisement
Parameter
Overheat protection
5.4 Configuring Green PoE
Set PoE off and on time.
Step 1
Select PoE Management > Green PoE.
Set PoE On Time and PoE Off Time.
Step 2
Step 3
Click
Step 4
Click OK.
5.5 Configuring Legacy Support
Enable Legacy Support in case of non-standard powered device.
Non-standard powered device means that the device supports 48 VDC PoE power supply, but does
not conform to IEEE 802.3af/at.
Step 1
Select PoE Management > Legacy Support.
Step 2
Click
Step 3
Click OK.
Description
Single port boots up when the temperature of powering chip has
exceeded the threshold.
to enable the green PoE.
Figure 5-2 Green PoE
of the corresponding port to enable legacy support.
24
Advertisement
Table of Contents
