Table of Contents
Advertisement
● Only the ports with the same speed rate, duplex, long distance and VLAN configuration can be in
the one aggregation group.
Step 1
Select Network Settings > Link Aggregation.
Step 2
Click Add.
Step 3
Select the Aggregation Group No..
Step 4
Select the Aggregation Group Mode from Static, LACP Active, LACP Passive, and Close.
Step 5
Set the Operational Key.
● You can only configure link aggregation when the Aggregation Group Mode is set as
LACP.
● The value ranges from 1 to 65535.
Step 6
Select the Timeout from Long Timeout or Short Timeout.
Step 7
Click OK.
4.6 Configuring SNMP Protocol
SNMP (Simple Network Management Protocol) is the standard protocol for network management in
Figure 4-6 Add link aggregation
Figure 4-7 Link aggregation
16
Advertisement
Table of Contents
