Installing the product to a control panel
This section shows the procedure to attach this product to a control panel.
1.
Fix mounting screws (x2) for the upper side of the product to the control panel.
2.
Hitch the notch on the right side of the product to the screw attached on the right side.
3.
Place the bell-shaped hole on the left side of the product on the screw on the left side of the control panel.
4.
Fix the mounting screws (x2) into the holes at the bottom of the product.
5.
Retighten all screws.
If it is difficult to tighten mounting screws, first remove the power supply module. ( Page 168 Replacement
of power supply module)
2 PRODUCT INSTALLATION
22
2.1 Product Installation