Appendix 10Wiring; Power Supply Module; Ethernet Connector - Mitsubishi Electric MELIPC MI5A1P User Manual

Appendix 10
This section shows the wiring of this product.
The bend radius (R) near the connector and ports should be 4 that of the cable external diameter.
Precautions
Turn OFF the power supply of this product before wiring.

Power supply module

For the wiring of the power supply module, see the following page.
Page 30 Wiring the Power Supply Module

Ethernet connector

This section shows the wiring of the Ethernet connector.
Wiring equipment
The following shows the equipment for wiring.
Standard (1000BASE-T/100BASE-TX/10BASE-T) and full duplex/half duplex communication modes are
determined by the product in accordance with the hubs being used. If hubs without auto negotiation
functionality are used, set the hub to match the communications mode.
■Ethernet cables and hubs (during Ethernet configuration)
Use Ethernet cables and hubs that meet the following conditions.
Ethernet cables
Standard
1000BASE-T
100BASE-TX
10BASE-T
Hubs
Ensure that hubs to use with an Ethernet configuration can handle the transmission speeds of communications.
APPX
152
Appendix 10 Wiring
Wiring
Specifications
Category 5e or better, (shielded, STP) straight cable
Category 5e or better, (shielded, STP) cross cable
Category 5 or better, (shielded, STP) straight cable
Category 5 or better, (shielded, STP) cross cable
Category 3 or better, (shielded, STP) straight cable
Category 3 or better, (UTP) straight cable
Category 3 or better, (shielded, STP) cross cable
Category 3 or better, (UTP) cross cable
Communication Connector
s speed
1 Gbps RJ45
100Mbps
10Mbps