Cc-Link Ie Field Network Connector - Mitsubishi Electric MELIPC MI5A1P User Manual

CC-Link IE Field Network connector

This section shows the wiring for a CC-Link IE Field Network connector.
Wiring equipment
The following shows the equipment for wiring.
■Ethernet cable
Use Ethernet cables that meet the following conditions.
Standard
• IEEE802.3(1000BASE-T)
• ANSI/TIA/EIA-568-B(Category 5e)
The CC-Link IE Field Network Ethernet cable is sold by Mitsubishi Electric System & Service, Co., Ltd.
Model name (Manufacturer)
SC-E5EW Series
(Mitsubishi Electric System & Service, Co., Ltd.)
Cables can be constructed at a specified length. Consult with your local Mitsubishi representative.
■Hubs
Use cables that meet all of the following conditions. Operation cannot be guaranteed if conditions are not met.
• Compliant with IEEE802.3(1000BASE-T) standards
• Incorporating auto MDI/MDI-X function
• Incorporating auto negotiation function
• Switching hub (Layer 2 switch)
*1 Repeater hubs cannot be used.
This shows introduced products.
Model name (Manufacturer)
NZ2MHG-T8F2 (Mitsubishi Electric Corporation)
NZ2EHG-T8N (Mitsubishi Electric Corporation)
Use the following hubs when using CC-Link IE Field Network synchronous communication functions.
Model name (Manufacturer)
NZ2MHG-T8F2 (Mitsubishi Electric Corporation)
NZ2EHG-T8N (Mitsubishi Electric Corporation)
Specifications
Category 5e or better, (double-shielded, STP) straight cable
Specifications
(Double-shielded, STP) straight cable
*1
Type
CC-Link IE-supported intelligent hub
Industrial-use switching hub
Type
CC-Link IE-supported intelligent hub
Industrial-use switching hub
Connector
RJ45
Maximum connection levels when
synchronization communications
functions are used
4
APPX
Appendix 10 Wiring
A
155