Table of Contents
Advertisement
Installation surface
Install the product on a flat surface.
If the installation surface is uneven, excessive force is applied to the printed-circuit board, which may cause malfunction.
Installation of the product with other devices, distances
Pay attention to the following points when installing this product with other equipment.
• To avoid installation close to vibration sources such as electromagnetic contactors and no fuse breakers, either install the
product in a different control panel or at a distance.
• Provide the following clearance between the product and other devices such as a contactor and relay to avoid influence
from the radiated noise and heat.
(1)
(1) Equipment mounted to the front of the product: 100 mm or more
(2) Equipment mounted to the left and right sides of the product: 50 mm or
more
(2)
(2)
2 PRODUCT INSTALLATION
2.1 Product Installation
2
21
Advertisement
Table of Contents
