Installing The Product To A Control Panel - Mitsubishi Electric MELIPC MI5000 Series User Manual

Startup
Hide thumbs Also See for MELIPC MI5000 Series:
Table of Contents

Advertisement

Installing the product to a control panel

This section shows the procedure to attach this product to a control panel.
1.
Fix mounting screws (x2) for the upper side of the product to the control panel.
2.
Hitch the notch on the right side of the product to the screw attached on the right side.
3.
Place the bell-shaped hole on the left side of the product on the screw on the left side of the control panel.
4.
Fix the mounting screws (x2) into the holes at the bottom of the product.
5.
Retighten all screws.
If it is difficult to tighten mounting screws, first remove the power supply module. ( Page 168 Replacement
of power supply module)
2 PRODUCT INSTALLATION
22
2.1 Product Installation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melipc mi5122-vw

Table of Contents