Setup The Radio And Network; Setup Terminal Emulation Parameters - LXE VX3X Reference Manual

Setup the Radio and Network

Setup the Radio and Network
Prerequisites
See "Chapter 5, "Wireless Network Configuration" for complete information.

Setup Terminal Emulation Parameters

Before you make a host connection, you will, at a minimum, need to know:
to properly set up your host session.
1. Make sure the mobile client network settings are configured and functional. If you are
connecting over wireless LAN, make sure your mobile client is communicating with the
Access Point.
2. From the Start | Programs, run LXE RFTerm or tap the RFTerm icon on the desktop.
3. Select Session | Configure from the application menu and select the "host type" that you
require. This will depend on the type of host system that you are going to connect to; i.e.
3270 mainframe, AS/400 5250 server or VT host.
4. Enter the "Host Address" of the host system that you wish to connect to. This may either be a
DNS name or an IP address of the host system.
5. Update the telnet port number, if your host application is configured to listen on a specific
port. If not, just use the default telnet port.
6. Select OK
7. Select Session | Connect from the application menu or tap the "Connect" button on the
Command Bar. Upon a successful connection, you should see the host application screen
displayed.
To change options such as Display, Colors, Cursor, Barcode, etc., please refer to the "RFTerm
Reference Guide" on the LXE Manuals CD.
E-EQ-VX3XRG-D
•
Network SSID or ESSID number of the Access Point
•
WEP or LEAP Authentication Protocol Keys
•
the alias name or IP address (Host Address) and
•
the port number (Telnet Port) of the host system
11
®
VX3X Reference Guide