Install Stylus Tether And Sleeve (Optional); Install/Remove Touchscreen Protective Film Optional) - LXE VX3Plus User Manual

30

Install Stylus Tether and Sleeve (Optional)

Carefully remove the paper backing from the Stylus Clip sticky. Firmly press the sticky side of the
clip onto the mobile device and hold in place for 15 seconds. Thread the tether through the end of
the stylus and tie the ends firmly to the Stylus Clip so that the ends don't interfere with placing the
stylus in the Stylus Clip. Place the stylus in the Stylus Clip when not in use.
An extra or replacement stylus can be ordered from LXE. See the section titled "Accessories" for
the stylus part number.

Install/Remove Touchscreen Protective Film Optional)

First, clean the display of fingerprints, lint particles, dust and smudges.
Remove the protective film from its container. Remove any protective backing from the film sheet
by lifting the backing from a corner of the film. Discard the backing.
Apply the film to the screen starting at one side and smoothing it across the display. If air bubbles
appear, raise the film slightly and continue smoothing the film across the display until it covers
the glass surface of the display.
If dust, lint or smudges are trapped between the protective film and the glass display, remove the
protective film, clean the display and apply the protective film again.
VX3Plus User's Guide
Install Stylus Tether and Sleeve (Optional)
E-EQ-VX3PLUSOGWW-B