Table of Contents
Advertisement
44
Display and Touchscreen
The VX3Plus Display is an LCD display capable of supporting Half VGA graphics modes.
Display size is half screen, 640 x 240 pixels. The display covering is designed to resist stains. The
touch screen allows signature capture and touch input. The display is either:
Display contrast adjustment is not necessary and the contrast adjustment key has no effect on the
VX3Plus.
The touch screen is a Resistive Panel with a scratch resistant finish that can detect touches by a
stylus, and translate them into computer commands. In effect, it simulates a computer mouse.
Only Delrin or plastic styluses should be used.
Note:
An extra or replacement stylus may be ordered from LXE. See the "Accessories" section for the
stylus part number.
Set the Display Backlight Timer
The Display Backlight Timer can be configured, if desired. For more information, please refer to
"Set the Display Backlight Timer" in the "VX3Plus Reference Guide".
Set the Display Brightness
The brightness on the color display is incremented or decremented one step each time the arrow
key is pressed until either the maximum or minimum brightness is achieved (8 steps). The
brightness setting is recalled at power up.
The LED for the 2
VX3Plus User's Guide
•
An active transmissive display optimized for indoor viewing, or
•
An active transflecive display optimized for outdoor viewing. A VX3Plus with this
display includes a "sun" logo to the bottom left of the keypad.
Always use the point of the stylus for tapping or making strokes on the display. Never use
an actual pen, pencil or sharp object to write on the touch screen.
•
2nd key then the <F10> key
•
Use the Up Arrow and Down Arrow keys to adjust brightness until the display
lightens or darkens to your satisfaction.
•
Press the Enter key to exit this mode.
nd
key blinks until the special editing mode (set display brightness) is complete.
Display and Touchscreen
E-EQ-VX3PLUSOGWW-B
Advertisement
Table of Contents
