Table of Contents
Advertisement
(4) Enter the User Name and Password registered on the NO-IP website.
(5) Click
Configuring PPPoE Settings
Purpose:
If you have no router but only a modem, you can use Point-to-Point Protocol over Ethernet
(PPPoE) function.
Steps:
1.
Enter the PPPoE settings interface:
Configuration > Network > Basic Settings > PPPoE
2. Check the Enable PPPoE checkbox to enable this feature.
3. Enter User Name, Password, and Confirm password for PPPoE access.
Note:
The User Name and Password should be assigned by your ISP.
For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The
password should be something of your own choosing (using a minimum of 8 characters,
including upper case letters, lower case letters, numbers and special characters) in order
to increase the security of your product.
Proper configuration of all passwords and other security settings is the responsibility of
the installer and/or end-user.
4. Click
Configuring Port Settings
Purpose:
You can set the port No. of the camera, e.g., HTTP port, RTSP port and HTTPS port.
Steps:
1.
Enter the Port settings interface:
Configuration > Network > Basic Settings > Port
© Hikvision
to save the settings.
Figure 6-4 PPPoE Settings
to save and exit the interface.
Advertisement
Table of Contents
