Table of Contents
Advertisement
One-touch Patrol
One-touch Park
Face Capture
4.5.3 Setting/Calling a Preset
Purpose:
A preset is a predefined image position. For the defined preset, you can click the calling button to
quickly view the predetermined image position.
Setting a Preset:
Steps:
1. In the PTZ control panel, select a preset number from the preset list.
2. Use the PTZ control buttons to move the lens to the desired position.
• Pan the camera to the right or left.
• Tilt the camera up or down.
• Zoom in or out.
• Refocus the lens.
3. Click
to finish the setting of the current preset.
© Hikvision
Click
to call one-touch patrol. For detailed
information of setting one-touch patrol, refer to Section
4.5.5 One-touch Patrol.
Click
to save the current view as the preset No. 32
and start park at the current position.
Before you start:
To use manual face capture, you should configure the
function first.
Configuration > Face Capture
Steps:
1. Click
to start manual face capture.
2. Select the target face in PTZ camera channel by
drawing a rectangle area.
3. Click the icon again to stop manual face capture.
Note:
The function is only available for certain camera models.
Figure 4-6 Setting a Preset
Advertisement
Table of Contents
