Table of Contents
Advertisement
6. Click
surveillance center, send email and trigger alarm output are selectable. Refer to Section 5.2.1
Configuring Motion Detection.
7. Click
5.2.3 Configuring Alarm Input
Steps:
1. Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2. Choose the Alarm Input No. and the Alarm Type. The alarm type can be NO (Normally Open)
and NC (Normally Closed).
3. Edit the name in
alarm input (optional).
4. Click
configuration is the same as the setting of the arming schedule for motion detection. Refer to
Section 5.2.1 Configuring Motion Detection.
5.
Click
Email, Notify Surveillance Center, and Upload to FTP/Memory Card/NAS, Trigger Alarm
Output and Trigger Recording. Refer to Section 5.2.1 Configuring Motion Detection for more
details.
6. You can also choose the PTZ linking for the alarm input. Check the relative checkbox and
select the No. to enable Preset Calling, Patrol Calling or Pattern Calling.
© Hikvision
tab to select the linkage method taken for tampering. Notify
to save the settings.
Figure 5-17 Alarm Input Settings
tab to enter the arming schedule setting interface. The arming schedule
tab to select the linkage method taken for alarm input, including Send
to set a name for the
Advertisement
Table of Contents
