Titan Pulsite Link Instruction Manual page 6

3 Electrical
Electrical and instrument connections are wired internally via 2 x PG7 Cable glands and 5mm
pitch terminal block connectors.
To access these connectors, simply undo the 4 rear screws and carefully remove the front
cover.
Description Specification
Power Supply 15-24Vdc Regulated
0.1 amp
Flowmeter Input Pulse (max. 5kHz)
Reed Switch (max. 400Hz)
Sensor Supply 5Vdc 50mA max
room temperature. (25mA at
high temperature)
Output Pulse NPN/PNP 2.5kHz
24V@20mA max.
Scalable pulse per litre
Output Analog 0-5Vdc / 0-10Vdc
16 bit
Adjustable flow range
4-20mA ACTIVE
16 bit
Adjustable flow range
© Titan Enterprises Ltd
+24VDC →
0VDC →
Power Input 0V
+VDC Supply to meter →
0VDC Supply to Flowmeter →
Pulse from flowmeter →
Pull up/down resistor required for NPN/PNP – see
wiring diagrams
Pulse Output to PLC/display
NPN or PNP
Pull up/down resistor required for NPN/PNP – see
wiring diagrams
+VDC to PLC/Display →
0VDC of circuit →
+mA to PLC/Display →
0VDC of circuit →
www.flowmeters.co.uk
Terminal Connection
Power Input +V
Flowmeter +5V Out
Flowmeter 0V
Flowmeter
→Digital Output
Analog Output V Out
Analog Output 0V
Analog Output mA Out
Analog Output 0V
PulsiteLink_Instruction_Manual_0722
6