Table of Contents
Advertisement
4.4 Flow Details Tab
The Flow Details tab displays the performance of the meter in real time.
The main large display reflects the meter readings showing on the Atrato LCD Display, if fitted,
and will mimic that display. The buttons either side have the functions selected on the
'Configuration' screen and work in parallel with the buttons on the Atrato flowmeter display unit
itself.
The Results Details indow below the rate and total display shows various relevant operational
parameters whilst the unit is operating, e.g., relay status and frequency output if these options
are selected.
Parameters:
•
Flow: This is the instantaneous flow rate and is updated approximately every 100
milliseconds.
•
Input: The measured frequency of pulses from the connected flowmeter/device.
•
NPN Output & PNP Output: If no selection is made "Not used" will be in the Description
column. See following text and chart for the display legends.
o OR: When NPN or PNP is set to "Output" and set to "Pulse" this will display the
frequency of the running output and the number of pulses per litre selected.
o OR: If it is selected to "Output" and set to "Flow switch" the Value column will
show the transistor status either "low" or "high" and the notes will show the
selected switch points.
•
Analog: Displays the chosen analog output and value.
© Titan Enterprises Ltd
www.flowmeters.co.uk
PulsiteLink_Instruction_Manual_0722
20
Advertisement
Table of Contents
