Titan 200 Series Operator's Manual
The ramp rack
Hide thumbs
Also See for 200 Series:
- User manual ,
- Operating manual (156 pages) ,
- Owner's manual (28 pages)
Subscribe to Our Youtube Channel
Related Manuals for Titan 200 Series
Summary of Contents for Titan 200 Series
- Page 1 THE RAMP RACK 200 SERIES PU-200 900008 Operator’s Manual Read the Operator’s Manual entirely. When you see this symbol, the subsequent instructions and warnings are serious follow without exception. Your life and the lives of others depend on it!
- Page 2 ASSEMBLY INSTRUCTIONS – PU-200 1. Remove the tailgate and the license plate from the truck. Newer trucks may require you to disconnect wiring for backup camera/ tailgate light. 2. Place strut channel nut into stake pocket bracket. The strut channel nut should be inserted so it will correspond with the mounting hole inside the bed.
- Page 3 5. Place storage shelf inside 24” front rack assembly, line up holes and insert (16) stainless ¼” screws with a Phillips screwdriver. A screwdriver can be helpful to get holes aligned properly. 6. Place assembled 24” front storage rack assembly onto front stake pockets.
- Page 4 9. Insert adjustable hitch. This is made to fit a 2” receiver hitch. Remove the license plate from the truck. This will be installed on the ramp during a later step. **Some trucks may require a sleeve spacer. ** 10. Remove the ramp pin from the tube of the dovetail.
- Page 5 14. Remove rubber grommet from ¾” marker light. Insert marker light through mounting hole. Re-install rubber grommet into the pre-drilled mounting hole in metal. Install marking light into grommet and press into place. 15. Install 6” oval rubber grommet into precut hole for taillight. Pull the taillight plug through the hole where the rubber grommet was installed, connect wiring, and press into place.
- Page 6 18. 18. Attach ramp to dovetail with ramp pin. Once ramp pin is in place secure with (1) ⅜” x ¾” flange bolt and (1) ⅜” flange nut. **Three people are recommended for this step** 19. While the ramp is in the down position, install gate spring latches.
-
Page 8: Parts Guide
PARTS GUIDE... - Page 11 ASSEMBLY INSTRUCTIONS - QD-100 1. Insert the custom jack into the adjustable hitch “A” frame and secure with jack mounting bracket and (2) ⅜” x 1½” carriage bolts and (2) ⅜” flange nuts. Ensure this is tightened down well to prevent your jack from slipping. 2.
- Page 12 PARTS DIAGRAM / EXPLODED VIEW...
- Page 13 Titan, its insurers, employees, officers, directors, associates, and agents from any and all claims, demands, damages, rights of action, or causes of action, present or future, whether the same be known or unknown, anticipated, or unanticipated, resulting from or arising out of the use of said equipment.
- Page 14 NEED HELP? CONTACT US FIRST. 1-800-605-7555 info@titanramps.com www.titanramps.com © 2021 Titan Brands...
Need help?
Do you have a question about the 200 Series and is the answer not in the manual?
Questions and answers