Table of Contents
Advertisement
Security Setup
Two Levels of Password Protection
The setup provides both a Supervisor and a User password. If you use both passwords, the Supervisor
password must be set first. The system can be configured so that all users must enter a password every time
the system boots or when Setup is executed, using either or either the Supervisor password or User password.
The Supervisor and User passwords activate two different levels of password security. If you select password
support, you are prompted for a one to six character password. Type the password on the keyboard. The
password does not appear on the screen when typed. Make sure you write it down. If you forget it, you must
drain NVRAM and reconfigure.
Supervisor Password
Indicates whether a supervisor password has been set. If the password has been installed, Installed displays. If
not, Not Installed displays.
User Password
Indicates whether a user password has been set. If the password has been installed, Installed displays. If not,
Not Installed displays.
Change Supervisor Password
Select this option and press <Enter> to access the sub menu. You can use the sub menu to change the
supervisor password.
Change User Password
Select this option and press <Enter> to access the sub menu. You can use the sub menu to change the user
password.
Clear User Password
Select this option and press <Enter> to access the sub menu. You can use the sub menu to clear the user
password.
Change Supervisor Password
Select Change Supervisor Password from the Security Setup menu and press <Enter>.
appears. Type the password and press <Enter>. The screen does not display the characters
Enter New Password:
entered. Retype the password as prompted and press <Enter>. If the password confirmation is incorrect, an
error message appears. The password is stored in NVRAM after the setup completes.
Change User Password
Select Change User Password from the Security Setup menu and press <Enter>.
r
appears.
Ente
New Password:
Type the password and press <Enter>. The screen does not display the characters entered. Retype the
password as prompted and press <Enter>. If the password confirmation is incorrect, an error message appears.
The password is stored in NVRAM after the setup completes.
Page 43 of 62 Pages
Advertisement
Table of Contents
