Table of Contents
Advertisement
Wait for 'F1' If Error
Disabled This prevents the ezPORT to wait on an error for user intervention. This setting should be used if there is a known
reason for a BIOS error to appear. An example would be a systemadministrator must remote boot the system. The computer
system does not have a keyboard currently attached. If this setting is set, the system will continue to boot up in to the
operating system. If 'F1' is enabled, the system will wait until the BIOS setup is entered. Enabled Set this value to allow the
system BIOS to wait for any error. If an error is detected, pressing <F1> will enter Setup and the BIOS setting can be
adjusted to fix the problem. This normally happens when upgrading the hardware and not setting the BIOS to recognize it.
This is the default setting.
Hit 'DEL' Message Display
Disabled This prevents the ezPORT to display Hit Del to enter Setup during memory initialization. If Quiet Boot is
enabled, the Hit 'DEL' message will not display. Enabled This allows the ezPORT to display Hit Del to enter Setup
during memory initialization. This is the default setting.
Boot Device Priority Use this screen to specify the order in which the system checks for the device to boot from.
Hard disk drives Use this screen to view the hard disk drives in the system.
Page 41 of 62 Pages
Advertisement
Table of Contents
