Verify Chassis Installation - Cisco Nexus 9808 Hardware Installation Manual

Connect Switch to the Network
RP/0/RP0/CPU0:ios#
Step 3 Enter a new password to use for this switch.
The software checks the security strength of your password and rejects your password if it is not considered
to be a strong password. To increase the security strength of your password, make sure that it adheres to the
following guidelines:
• at least eight characters
• minimizes or avoids the use of consecutive characters (such as "abcd")
• minimizes or avoids repeating characters (such as "aaa")
• does not contain recognizable words from the dictionary
• does not contain proper names
• contains both uppercase and lowercase characters
• contains numbers as well as letters
Note
Tip
When you enter a strong password, the software asks you to confirm the password.
Step 4 Reenter the password.
When you enter the same password, the software accepts the password.
Step 5 Enter the configuration mode.
Step 6
Enter the IP address for the management interface. If using dual RPs, enter the IP address on both management
interfaces.
Step 7
Enter a network mask for the management interface.
Step 8 The software asks whether you want to edit the configuration. Enter 'no' to decline.

Verify Chassis Installation

After installing the chassis, use the following show commands to verify the installation and configuration in
the EXEC mode. Any issue if detected, take corrective action before making further configurations.
Command Description
show module Displays the state information of each card.
show redundancy Displays the status of supervisor module redundancy.
Clear text passwords cannot include the dollar sign ($) special character.
If a password is trivial (such as a short, easy-to-decipher password), the software rejects that
password. Passwords are case sensitive.
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
Verify Chassis Installation
55