Table of Contents
Advertisement
Replace a Supervisor Module
Figure 46: Remove Supervisor Module from Chassis
g) Pull to rotate the levers away from the front of the module (see Callout 2 in the above figure)
The module unseats its connectors from the midplane and moves slightly out of the chassis.
h) Use one hand to hold the front of the module, place your other hand under the module to support its weight,
pull the module out of the chassis, and set it on an antistatic surface or inside an antistatic bag.
Note
Step 4
To install a new module, follow these steps:
a) If any of the ejector levers are in closed position slide the latch on the ejector lever outwards from the
lever center and pull to rotate the lever away from the front of the module.
This action opens the lever so that the module can be fully inserted into the slot.
b) Hold the front of the module with one hand and place your other hand under the module to support its
weight.
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
78
While performing OIR of the module, wait for 30 seconds before inserting the same or new
module in the same slot. This will allow the module to boot properly and reach operational state.
Replace Chassis Components
Advertisement
Table of Contents
