Table of Contents
Advertisement
Connect Switch to the Network
Note
Caution
Before you begin
You must have completed the initial switch configuration.
Procedure
Step 1
Connect a modular, RJ-45, UTP cable to the MGMT ETH port on the Supervisor Module.
Step 2
Route the cable through the central slot in the cable management system.
Step 3
Connect the other end of the cable to a 100/1000 Ethernet port on a network device.
What to do next
You are ready to connect the interface ports on each of the line cards to the network.
Transceivers, Connectors, and Cables
Transceiver and Cable Specifications
To determine which transceivers and cables are supported by this switch, see
Compatibility
To see the transceiver specifications and installation information, see
Upgrade
RJ-45 Connectors
The RJ-45 connector connects Category 3, Category 5, Category 5e, Category 6, or Category 6A foil twisted-pair
or unshielded twisted-pair cable from the external network to the following module interface connectors:
• Switch chassis
In a dual Supervisor Module switch, you can ensure that the active Supervisor Module is always connected
to the network by connecting the management interface on both Supervisor Module to the network. That is,
you can perform this task for each Supervisor Module. When the Supervisor Module is active, the switch
automatically has a management interface that is running and accessible from the network.
To prevent an IP address conflict, do not connect the MGMT 100/1000 Ethernet port until the initial
configuration is complete.
Information.
Guides.
• CONSOLE port
• MGMT ETH port
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
Transceivers, Connectors, and Cables
Cisco Transceiver Modules
Cisco Transceiver Modules Install and
47
Advertisement
Table of Contents
