Table of Contents
Advertisement
Replace Chassis Components
c) Align the back of the module to the guides in the open Supervisor slot and slide the module all the way
into the slot.
The module stops when its front is about 0.25 inches (0.6 cm) outside the front of the chassis.
d) Rotate the levers firmly all the way to the front of the chassis. Then firmly push the tip of the levers
towards the faceplate till the latch hook locks in place behind the faceplate. You may hear a click or see
the latch engage. (See Callout 1 in the below figure.)
Make sure that the other end of both levers engages behind the latching slot on the faceplate so that the
module fully seats onto the connectors on the midplane.
Note
To confirm that the module is installed properly, pull the black tip of each ejector lever lightly,
and make sure the lever does not pop out.
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
Replace a Supervisor Module
79
Advertisement
Table of Contents
