Siemens SIMOCODE 3UF Programming And Operating Manual page 158

Online Settings and Displays
17.10 Faults
Miscellaneous - General
Indication
External Fault 1 to 6
Bus
PLC/DCS
Hardware fault Basic Unit
Module fault
Temporary components
Configuration fault
analog module 1/2 open circuit
158
Meaning/Possible cause/Acknowledgement/Error processing
A signal is pending at the input (socket) of the standard
function.
External fault 1, 2, 3, 4,5 or 6.
Check the motor feeder.
Acknowledgement depends on parameterization.
Further information: External Fault (1 to 6).
The PROFINET communication has been or is being
interrupted.
Check the PROFINET connection (plugs, cables, etc).
Acknowledge with "Reset", if Auto-Reset is not activated.
Further information:Watchdog (PLC/DCS monitoring)
The PLC which controls the feeder was or is in the STOP state.
Check the operating status of the PLC.
Acknowledge with "Reset", if Auto-Reset is not activated.
Further information: Watchdog (Bus Monitoring, PLC/DCS
Monitoring).
The hardware of the SIMOCODE pro basic device is defective.
Replace the basic unit.
At least one SIMOCODE pro module is not ready for use.
Possible causes:
Connecting cable is defective or has not been plugged in
•
correctly.
Module is defective. Replace the module.
•
Acknowledge with "Reset".
Fault - Temporary components (memory module, addressing
plug, PC cable).
Replace the defective component.
Acknowledge with "Reset".
The configured device configuration does not match the current
configuration.
Approach:Check if all configured components are present.
Check the actual configuration using "Configuration".
Acknowledge with "Reset".
Further information: Actual configuration.
A wire break has occurred in the analog value measuring
circuit.
Check the measuring transducer and the measuring circuit.
Acknowledge with "Reset".
Further information: Analog Module.
Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
SIMOCODE PRO V PN FDI