Activating Using At Commands - Sierra Wireless AirLink PinPoint X User Manual

PinPoint X 1x/EV-DO
26
Your modem is now ready to be used as a DUN device for any applications on
your computer needing a network connection. If you have DUN installed for more
than one modem, you will need to specify in your application which DUN to use.
Unless it is the only DUN, your PinPoint X may not be the one your computer
sees as a default.

Activating Using AT Commands

An alternate method to configure and activate your PinPoint X is by using AT
commands sent directly to the modem with a terminal application. (Refer to the
troubleshooting section). This method is recommended only in situations where
the Setup Wizard is not available and/or when the configuration for the PinPoint X
is unusual.
Caution: It is not possible to activate the PinPoint X using either ACEmanager or AceNet.
1. Set telnet timeout in to 20 minutes.
2. Save the telnet setting.
3. Enter the user name of your account (NAI). The user name is usually
expressed as an email address with phone number of the account (example,
1234567@carrier.com). This information should be provided by your carrier.
You may not need this step.
AT*NETUID=[NAI]
4. Enter the password of your account. This information should be provided by
your carrier. You may not need this step.
AT*NETPW=[password]
5. Verify ALEOS has established communication to the internal hardware.
6. Enter the activation command appropriate for your type of account. The SID
and NID are optional and only required if your account type uses them.
· If you have the same number for the MIN and MDN or MSID:
AT*PROVISION=MSL,MDN[,SID,NID]
· If you have the different numbers for the MIN and MDN or MSID:
AT*PROVISION2=MSL,MDN,MIN/MSID[,SID,NID]
7. Start the IOTA session.
AT!IOTASTART
Status will be output until IOTA completes with 'IOTA Successful' or ' 1012
ERROR'.
20070914