System Clean - Panasonic HL-SF498S Operating Instructions Manual

Cleaning Programs

System Clean

Cleaning
Drain Water System Clean
An alert will show in the display at the
end of a cooking program indicating a
system clean is needed. An alert will
also show in the information panel.
Manual Auto
Run the system clean operation.
The first stage of this program cleans
the system with a citric acid solution.
The second stage runs water through
the system to rinse the pipes.
Make a solution of 8 g citric acid and
200 ml of water, add the solution to the
water tank.
Add a solution of
8g citric acid and 200ml of water
to the water tank.
Touch Cleaning, then System Clean.
Remove, empty and re-insert Drain tank
86
EN
before touching Stop/Start.
12:00
Steam Clean
12:00
Combi
Cleaning l System Clean
The program will start and the time
in the display will count down. The
program will run for approximately
30 minutes.
After the program has paused, an alert
will show to empty the drain tank. Rinse
the water tank and re-fill with 200 ml of
water.
Empty the drain tank.
Rinse the water tank and refill with 200ml of water.
Touch Stop/Start. The program will run
for approx. 1 minute.
Empty the drain tank after the program
has finished.
Note
§
If the System Clean program is
not used regularly, the pipe will
get blocked and the steaming
performance will be less effective.
§
Do not remove the drain tank
during the System Clean program.
If the drain tank is removed during
the program, it will stop and goes
back to clock display.
§
Empty both tanks and clean with
warm water after the program has
finished.
12:00
30 00
m s
Duration