Running The Quick Start Example Project; Figure 4. Usb Serial Device In Windows Device Manager - Renesas CK-RX65N Quick Start Manual
Hide thumbs
Also See for CK-RX65N:
- User manual (34 pages) ,
- Getting started manual (58 pages) ,
- Getting started manual (55 pages)
Table of Contents
Advertisement
Renesas RX Family
4.2 Running the Quick Start Example Project
To run the Quick Start example project, use the following instructions:
1. On power up or RESET, the four user LEDs will take on the following states:
LED2 RGB – Off
LED3 Green – Steady, full intensity
LED4 Blue – Blinking at 1 Hz frequency
LED6 Red – Off
2. Press the user button (S2) on the CK-RX65N board to change the blinking frequency of the user LED4
(blue). With every press of the first user button (S2), the frequency will switch from 1 Hz to 5 Hz to 10 Hz
and cycle back.
3. On the host PC, open Windows Device Manager. Expand Ports (COM & LPT), locate USB Serial
Device (COMxx) and note down the COM port number for reference in the next step.
R20QS0031EG0100 Rev.1.00
May.26.22
Figure 4. USB Serial Device in Windows Device Manager
CK-RX65N – Quick Start Guide
Page 10 of 28
Advertisement
Table of Contents
