Modifying, Generating, And Building The Quick Start Example Project; Figure 23. Opening The Configurator; Figure 24. Opening The Configurator - Renesas CK-RX65N Quick Start Manual

Renesas RX Family

5.3 Modifying, Generating, and Building the Quick Start Example Project

This section provides instructions to modify the Quick Start example project. The Quick Start example project
can be modified by editing the source code and reconfiguring the properties of the MCU peripherals, pins,
clocks, interrupts, and so forth.
Note: The specific modifications that can be performed to the Quick Start example project are not
prescribed in this QSG.
1. Once the Quick Start example project is imported, click the quickstart_ck_rx65n_ep.scfg file to open
the configurator. The configurator provides an easy to use interface to configure the properties of the
MCU peripherals.
2. For example, in the Components tab of the configurator, the user can click to select a module to modify
its configuration settings, as required. Figure 25 illustrates modifying the IRQ configuration.
Note: To access the component properties, the view must be set to Smart Configurator. Using the Open
Perspective button, if necessary.
R20QS0031EG0100 Rev.1.00
May.26.22

Figure 23. Opening the Configurator

Figure 24. Opening the Configurator

CK-RX65N – Quick Start Guide
Page 22 of 28