Sensor Calibration Information; Miscellaneous Functions; Application-Specific Information - Hach Met One 6000 Series User Manual

A.9 Sensor calibration information
Address Register description
900–903 Reserved
904–943 Sensor calibration curve sizes
944–983 Sensor calibration curve voltages
984–985 Reserved
986 Nominal flow
987–996 Reserved
997 Sensor type
998–1089 Reserved
1090 Sensor flow measurement present
1091–1099 Expansion
A.10 Miscellaneous functions
Address Register description
1100 Set Write access password
1101 Module reset
1102 Reserved
1103 Save all settings
1104 Default settings
1105–1199 Expansion
1
It is recommended to reset the 6000 using register 1101 after saving with register 1103.
A.11 Application-specific information
Address Register description
1200 Run status
1201–1259 Reserved
1260–1299 Expansion
The sensor calibration information register is used for instruments that can electronically
adjust the calibration circuitry or algorithm. The sensor information can be read from a
plug and play sensor or can be loaded at the factory or by qualified field personnel.
Table 25 Sensor calibration information
Table 26 shows the register blocks to perform a specialized action, such as resetting the
instrument (hardware reset) and saving all instrument configuration parameters to
non-volatile EEPROM memory.
Table 26 Miscellaneous functions
1
Table 27 shows application specific register blocks.
Table 27 Application specific
Access
R
Access Size (bytes) Data format
R/P 80
R/P 80
R/P 2
R/P 2
R/P 2
Access Size (bytes) Data format
W 2
W 2
W 2
W 2
Size (bytes) Data format
2 0=Delay, 1=Start, 2= Stop, 3=Count, 4=Hold
Modbus register maps
Size (20 points maximum)
format: XXX.XXX
Note: Resolution is 0.1 micron
mV (20 points maximum)
format: XXXX.XX
Range: 1–10000, 1 = 0.01cfm
1 = liquid, 2 = air
0 = not present, 1 = present
1 = reset
1 = save
1 = default
59