Wireless Setup - Hach Met One 6000 Series User Manual

Operation
Field
MAC
DHC/APIPA
IP Address
Subnet mask
Server port
Client port
Gateway
Remote server IP

4.3.1.3 Wireless setup

Field
Channel
Data rate
38
Table 11 Ethernet field description
Description
MAC Media access control: unique permanent hardware address
(read-only)
Enables or disables static or dynamic IP addressing by connection to a
DHCP server. When enabled, the counter will get an IP address and
subnet mask automatically on power up.
If a DHCP server is not available, the counter will use APIPA for an IP
address and subnet mask. APIPA IP address range: 169.254.0.0 to
169.254.255.255; subnet mask: 255.255.0.0 (Class B network).
For static IP addresses, each LAN-based instrument must have a
unique IP address. Range: 169.254.0.0 to 169.254.255.255 (e.g.
169.254.180.43).
Instruments of the same type that communicate with a single software
package such as FMS use the same subnet mask. Range: 0 to 255,
integer only.
ModbusTCP server listen port. Range: 0 to 65535, integer only.
Not available
Not available
Not available
Refer to Figure 27 and Table 12
Figure 27 Wireless section of utility program
Table 12 Wireless field description
Description
Channel when using Ad Hoc mode (peer to peer). When used with a
Wireless LAN the channel to be used is determined by the Access
Point, and the instrument Wireless radio will set the channel
automatically.
Data Rate for communications. Use lower Data Rate numbers if
increased distance is needed between the instrument and the Access
Point. Selections are 1Mbps, 2Mbs, 5.5Mbps 11Mbps, 18Mbps,
24Mbps, 36Mbps, and 54Mbps. See the Auto Fallback field
description.
for description of the fields for Ethernet configuration.
Default
Read only
Disabled
169.254.1.2
255.255.0.0
502
Disabled
Disabled
Disabled
Default
11
54Mbps