Hach Met One 6000 Series User Manual page 41

Field Description
SSID
Security
Encryption
Authentication
Network type
Key type Selects the Key type as Hex or PassPhrase.
Country
Auto fallback Enables automatic Data rate. See the Data Rate Field.
Roaming
Enable radio
PassPhrase/Key
PassPhrase/Key retype
Firmware ver
Table 12 Wireless field description (continued)
Service Set Identifier name used to identify the Wireless LAN to be
used. The SSID should use standard alpha numeric characters and
avoid punctuation, spaces, or other special characters. The SSID
should be a minimum of 8 characters in length.
Security authentication for the Wireless LAN. Selections available are
Disabled, WEP, WPA, and WPA2
Sets the Encryption based on the Security settings of the Wireless
LAN. Pairwise and Group encryption is available. Disabled Security
uses Open Authentication. WEP security selection allows 64 or 128 bit.
WPA security selection allows TKIP or TKIP/WEP. WPA2 security
selection allows CCMP, CCMP/TKIP, CCMP/WEP, TKIP, and
TKIP/WEP.
Authentication can be selected as Open or Shared (PSK or
Pre-Shared Key). When using a PassPhrase or Hex Key the
Authentication should be set to Shared.
Sets the Wireless communication Network Type as Ad Hoc or
Infrastructure. Use infrastructure when connecting to a Wireless LAN.
Country where the instrument is installed. Selections are US, France,
Japan, Others, Spain, and Canada. Consult the factory for other
country settings.
If enabled, Roaming manages the dynamic list of APs belonging to the
same network as the AP to which the instrument is currently
associated and stores relevant selection criteria for this list.
When checked the radio will operate normally. When unchecked the
radio will not communicate.
This field contains the actual network encryption key or PassPhrase. A
PassPhrase can be up to 63 alpha numeric or 64 Hex characters in
length and should be at least 20-character minimum. When using
hexadecimal for WEP, the key can only be 5 (WEP64) or 13
(WEP128), i.e., 1C-FD-BA-CF-2E for WEP64. The instrument only
uses the first of four WEP keys. Hex values are represented by ASCII
characters (not binary). The characters entered into this field are
hidden. By default the key / passphrase is blank.
PassPhrase/Key is retyped in this field to verify the entry is correct.
The characters entered in this field are hidden.
Displays the firmware version of the Wireless Radio for diagnostic
purposes.
Operation
Default
6000WIFI
DIsabled
Disabled
Open
Infrastructure
PassPhrase
US
DIsabled
Disabled
Enabled
Blank
Blank
6.5.0.0 or newer
39