Table of Contents
Advertisement
4.2.2.1 LAN setup
For configuration through a network, only the LAN settings can be changed. All other
settings must be changed through local setup by direct connection to the service port on
the counter or through a ModbusTCP connection.
1. In the utility program, select
shown
(Figure
24). The software will search for LAN instruments.
2. If LAN instruments are found, the instruments will be listed as shown in
Select an instrument to show the LAN Instrument Settings.
3. Change the instrument settings if necessary. Refer to
description of the settings. When configured as necessary, click
A ModbusTCP connection can be made where all the Modbus registers are available.
The user can then access all configuration options in the Modbus register map (refer
to
Appendix A on page
Figure 24 LAN setup for Ethernet units
Error messages
If an error message such as "Invalid IP setting" is shown, refer to
values that can be used. Enter a value in the range for the setting.
. The LAN Based Setup window will be
LAN SETUP
53).
Operation
Figure
Figure 23
and
Table 9
for a
SAVE SETTINGS
Table 9
to find the
24.
.
35
Advertisement
Table of Contents
