Page Selection - Kyocera KM-1530 User Manual

User Guide
Note: The quality and effectiveness of the printed and photocopied security
watermark is dependent on the particular printing system and the settings used.
Before printing a security watermark, it is necessary to adjust the calibration and print
calibration pages. It is also necessary to adjust the calibration, then print calibration
pages, whenever certain changes are made to the printing system or security
watermark settings. See Adjust Calibration on page 9-13 for more information on
how to perform these important steps.

Page Selection

Page selection options are enabled after a security watermark is selected from the
list. Choose one of the following:
All pages
The security watermark prints on every page of the document.
First page only
The security watermark prints only on the first page of the document.
All pages except first page
The security watermark prints on all pages of the document except the first page.
Only on specified pages
To print the security watermark on specific pages, type individual page numbers
separated by commas in the text box, or a page range separated by a hyphen.
For example, if you type 2 in the text box, the security watermark prints only on page
2. If you type 1, 3, 5-12 the security watermark prints on page 1, page 3, and pages
5 through 12.
If the Only on specified pages option is selected and you click OK without entering
any numbers, you will be prompted to specify page numbers.
Print onto front outside cover
Select this option to print the security watermark on the front cover page. Print onto
front outside cover is enabled when Cover mode is selected in the Publishing tab.
When printing is specified for the first page under Page Selection and Front outside
is selected In the Publishing tab, Print onto front outside cover is automatically
selected by the driver. (Even though the check box shows as selected, the option is
disabled.)
If you want, in the Publishing tab you can also select different media for the covers
than that used for the rest of the print job. For more details on Cover mode, see the
Publishing chapter in the KX Driver User Guide.
Advanced
9-10