Job Storage - Kyocera KM-1530 User Manual

Job
2
3
4
5
6
7
8
9
10
11
12
13
14
15
8-17
Press the or
Press the key to open the submenu.
Press the or
Press the ENTER key, the user name appears with a blinking question mark [ ? ].
If the user name is correct, press the ENTER key. Otherwise, press the
until the correct name appears.
The job name appears with a blinking question mark [ ? ]. Press the ENTER key.
The user name shown is specified following the instructions in
page 2-4. If this is the correct job for printing, press the ENTER key.
Otherwise, press the
ENTER key.
Enter the four-digit access code created in
Press the or
Press the or key to move the cursor right and left.
Press the ENTER key. Use the
printing.
Press the ENTER key to start printing.
After printing, the job will be automatically deleted from the hard disk. To delete the
job without printing it, follow the same procedure as in
page 8-15.

Job Storage

The Job storage feature saves jobs on the hard disk for future printing, even if the
printing system is switched off. You can also use access codes to restrict the printing
of forms.
key repeatedly until e-MPS > appears.
key repeatedly until >Private/Stored appears.
or key until the correct job name appears, then press the
key to increase or decrease the number.
or key to specify the number of copies for
Identification
Private Print on page 8-16.
Delete Quick Copy Jobs
2
3
4
5
or key
6
7
on
8
9
10
11
12
13
14
on
15
KX Driver