Kyocera KM-1530 User Manual page 47

User Guide
Auto Configure currently supports these ports for Microsoft Windows operating
systems:
• Windows 98 and Me – KPrint ports (Raw mode, LPR, and IPP) only
• Windows NT 4.0 – KPrint ports (Raw mode, LPR, and IPP) only
• Windows 2000 – TCP/IP Ports and KPrint Ports (Raw mode, LPR, and IPP)
• Windows XP and Vista – TCP/IP Ports only
TCP/IP port can be either an IP address or the printing system name (Host name).
Note: Auto Configure is not supported for Microsoft Windows 95.
To use this feature, click Auto Configure. An "in progress" message will appear.
The check box settings in the Device options list will be changed and the 3D image
will be updated according to the device options installed. Memory and RAM Disk
information will also change based on the setting information returned.
Under the following conditions the Auto Configure tool cannot communicate with the
printing system:
• The printing system is powered off or is in the middle of the startup process. In
such cases, Auto Configure will display the following message after the time out.
Printer Properties
2-16