Using Hole Punch - Kyocera KM-1530 User Manual

Finishing
1
2
3
4
5
6
5-6

Using Hole Punch

In your application, open the Print dialog box, then open Properties. (Select Print
from the File menu, and select Properties.)
In the Basic tab, under Destination, select a face-up or face-down finishing tray.
Click the Finishing tab, then select Punch.
Select the number of hole punches: 2 hole, 3 hole, or 4 hole. Available punch options
are set in the Device Settings tab and depend on the punch unit being installed on
the device and selected. For further details, refer to
page 2-1. For information on positioning the hole punches, refer to
Punch below.
• For metric specification, use 2 hole and 4 hole punch options.
• For inches specification, use 2 hole and 3 hole punch options.
Click OK to return to the Print dialog box.
Click OK to start printing.
The print job will be punched by the finishing device and delivered to the output tray.
For further details about hole punch specifications, refer to your finishing device's
Operation Guide.
Position the Hole Punch
Note: Some models do not support the punch position option.
Installing Optional Devices
Position the Hole
KX Driver
1
2
3
on
4
5
6