Mounting Steps With Screw Connection For Suspension Cable - Vega VEGAWELL 52 Operating Instructions Manual

VEGAWELL 52 • 4 ... 20 mA/HART Pt 100
3. Slide the clamping jaws upward and push the suspension cable
between them
4. Hold the suspension cable, push the clamping jaws downward
and fix them with a light blow
Disassembly is carried out in reverse order.
4.3 Mounting steps with screw connection for
suspension cable
Fig. 7: Configuration, screw connection of suspension cable
1 Suspension cable
2 Sealing screw
3 Cone bushing
4 Seal cone
5 Screw connection for suspension cable
6 Seal
Mount VEGAWELL 52 with screw connection for suspension cable as
follows:
1. Weld the welded socket into the vessel top
2. Lower VEGAWELL 52 to the requested height by means on the
welded socket G1½ or 1½ NPT on the vessel side
3. Shift the suspension cable from below through the opened
threaded fitting
4. Slide the sealing cone and the cone sleeve over the suspension
cable, fasten manually with the seal screw
5. Screw the screwed connection into the nozzle, tighten with SW 30
and then tighten seal screw with SW 19
How to correct the height:
1. Loosen seal screw with SW 19
2. Slide seal cone and cone sleeve to the requested position on the
cable
3. Fasten the seal screw
Disassembly is carried out in reverse order.
4 Mounting
1
2
3
4
5
6
13