Mounting; General Instructions - Vega VEGAWELL 52 Operating Instructions Manual

Process conditions
Suitability for the ambient
conditions
Transport and mounting
protection
Installation position
VEGAWELL 52 • 4 ... 20 mA/HART Pt 100
4

Mounting

4.1

General instructions

Note:
For safety reasons, the instrument must only be operated within the
permissible process conditions. You can find detailed information on
the process conditions in chapter " Technical data" of the operating
instructions or on the type label.
Hence make sure before mounting that all parts of the instrument ex-
posed to the process are suitable for the existing process conditions.
These are mainly:
•
Active measuring component
•
Process fitting
•
Process seal
Process conditions in particular are:
•
Process pressure
•
Process temperature
•
Chemical properties of the medium
•
Abrasion and mechanical influences
The instrument is suitable for standard and extended ambient condi-
tions acc. to DIN/EN/IEC/ANSI/ISA/UL/CSA 61010-1. It can be used
indoors as well as outdoors.
Depending on the transmitter, the VEGAWELL 52 is supplied with a
protective cap or a transport and mounting protection.
Fig. 4: VEGAWELL 52, transport and mounting protection
1 Transmitter
2 Transport and mounting protection
Remove this protection after mounting and before setting up the
instrument.
In case of slightly contaminated measured media, the transport and
mounting protection can remain on the instrument as an impact pro-
tection during operation.
Lateral movements of the transmitter can cause measurement errors.
For this reason, mount the instrument in a calm area or in a suitable
protective tube.
4 Mounting
1
2
11