Section 10: Physical Connections And Configuration Settings; Input Power (24V Dc-In); Graphics Interface; Ethernet Ports - Emerson RXi HMI User Manual

RXi HMI User Manual
GFK-3231A
Section 10:
Configuration Settings

Input Power (24V DC-in)

To connect to power, follow these steps:
Be sure to connect a DC power cord to this 3-pin power connector. Using a voltage out of the
range may fail to boot the system or cause damage to the system board.
10.1

Graphics Interface

The RXi HMI uses a DisplayPort to connect to a display device such as a computer monitor. The
DisplayPort connection will be used to transmit both audio and video. If additional configuration is
required, visit the Chipset menu in the device BIOS on startup.
10.2

Ethernet Ports

The RXi HMI has Four Base-T Ethernet Ports. Use the LAN ports to connect to a local area network
through a network hub or router. If additional configuration is required, visit the Wakeup
Configuration menu in the device BIOS on startup.
10.2.1

Ethernet Port Operation LEDs

Physical Connections and Configuration Settings
Physical Connections and
1. Verify that the power cable is not energized.
2. Loosen the screw clamps on the mating power
connector.
3. Strip the insulation from the power cables.
4. Secure the power cable to the mating connector, noting
polarity, and tighten the screw clamps. The torque for the
attaching screws is 0.3 Nm (2.26 in-lb).
5. Apply dc power to the unit. During normal startup and
operation, the LED status indicator displays as follows:
•
Solid amber while the RXi HMI unit is starting up
• Solid green during normal operation
LED LED State
Speed Yellow, ON
Link Activity Green, ON
Section 10
Jan 2022
Operating State
10/100/1000
Link Status
96