Summary of Contents for Emerson Rosemount 8700 Series
Page 1
Manual Supplement 00809-0300-4727, Rev AA Rosemount 8700 Series June 2005 Integral Mount to Remote Mount Conversion Start Step 1: Disassembling the Tube and Transmitter Step 2: Preparing the Flowtube Step 3: Preparing the Transmitter Step 4: Wiring the Tube and Transmitter Step 5: Perform a Loop Test www.rosemount.com...
Page 2
This installation guide provides basic guidelines. It does not provide instructions for detailed configuration, diagnostics, maintenance, service, troubleshooting, or installations. Refer to the Rosemount 8700 Series reference manual (document number 00809-0100-4727) for more instruction. The manual and this supplement are also available electronically on www.rosemount.com.
Page 3
Manual Supplement 00809-0300-4727, Rev AA Rosemount 8700 Series June 2005 1: D ISASSEMBLING THE UBE AND RANSMITTER 1. Shut off the power going to the magnetic transmitter. 2. Remove the cover on the terminal strip side of the electronics housing.
Page 4
Manual Supplement 00809-0300-4727, Rev AA Rosemount 8700 Series June 2005 2: P REPARING THE LOWTUBE 1. Remove the existing o-ring and discard appropriately. 2. Replace the o-ring with the new one supplied with the Remote Junction Box in the conversion kit.
Page 5
Manual Supplement 00809-0300-4727, Rev AA Rosemount 8700 Series June 2005 3: P REPARING THE RANSMITTER 1. Position the remote mount terminal box adjacent to the transmitter and carefully feed the wire leads so that they are accessible from the electronics access of the transmitter.
Page 6
Manual Supplement 00809-0300-4727, Rev AA Rosemount 8700 Series June 2005 4: W IRING THE UBE AND RANSMITTER 1. Follow the procedures outlined in the magnetic flow meter manual for making the proper wiring terminations between the Transmitter Remote Terminal box and the Flowtube Terminal Junction Box.
Need help?
Do you have a question about the Rosemount 8700 Series and is the answer not in the manual?
Questions and answers