Using Your Extractor - CDA ECNK91 Instructions For Installation, Use And Maintenance Manual

Using your extractor

For best performance, you should switch on the extractor
15 minutes before starting to cook and leave it to run for
approximately 15 minutes after the end of cooking.
Fig. 1
Control Panel
A - Power button
B - Down speed button
C - Display window
Power button: Press once, the motor will enter the low-speed state, the
down speed button: Touch this key to decelerate the wind speed, the
gear sequence is: 3 2 1. When the display window shows 1 (that is the
Speed-up key: Touch this key to accelerate the wind speed, the gear
sequence is: 1 2 3. When 3 is displayed in the display window (that is,
the motor is in a high-speed state, pressing this key does not work).
Illumination key: This key is independent and not controlled by the
Display window: Motor speed gear display, words 1,2,3,etc. can appear.
Delay function: long press the power button (2 seconds): enter the delay
function, delay 15 minutes, the wind speed will stop after 15 minutes.
During the delay, the wind speed can be easily adjusted, and the delay is
not hindered.
6
D - Speed up key
E - Lamp button