Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for CDA EDD62
Summary of Contents for CDA EDD62
- Page 1 EDD62 EDD92 Downdraft extractor Installation, use and maintenance...
-
Page 2: Table Of Contents
Contents Important information Using your extractor Changing the charcoal filter Mounting your extractor Ducting and ventilation Troubleshooting 10 Installation 12 Guarantee 13 Mains electrical connection 14 Energy Efficiency Information 2 | Instruction Manual... -
Page 3: Important Information
Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes. - Page 4 IMPORTANT INFORMATION FOR THE CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/ At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer providing appliance recycling services. Disposing of a household appliance seperately avoids possible negative consequencces for the environment and helath.
-
Page 5: Using Your Extractor
Using your extractor For best performance, you should switch on the extractor 15 minutes before starting cooking and for approximately 15 minutes after cooking. Light Middle High Fig.1 Control panel Touch the on key for 2 seconds to raise the extraction panel. Once the extraction panel has risen halfway, the fan will start working at low speed Touch the off key for 2 seconds to lower the extraction panel. - Page 6 Care and Maintenance IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a non-abrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings.
-
Page 7: Changing The Charcoal Filter
Changing the charcoal filter To ensure the best performance of your extractor, you should replace the charcoal filter every four to six months, depending on use. To replace the charcoal filter: Unscrew the panel on top of the motor housing box by •... -
Page 8: Mounting Your Extractor
Mounting your extractor When the extractor is to be installed behind a gas hob, the minimum distance between the hob and extractor must be 30mm. If fitting behind an electric hob, the minimum distance between the hob and extractor must be 20mm. If the instructions provided with your gas hob state that the required distance between the hob and extractor must be greater than specified above, then that is the distance that should be... -
Page 9: Troubleshooting
Troubleshooting In the event of your appliance requiring technical assistance and/or spare parts, please contact CDA Customer Care. In this case it is necessary to state all the appliance data on the rating plate, such as model, serial number etc. This information can be found behind the grease filter. -
Page 10: Installation
3) Make a rectangular cut-out in the worktop to accommodate the extractor. The dimensions of the cut-out should be:- EDD62 - 510 x 100mm Fig.7 EDD92 - 810 x 100mm 10 | Instruction Manual... - Page 11 4) If your extractor has been supplied with the motor housing already mounted on the main body, this needs to be dismantled to enable the extractor to be inserted through the worktop cut-out 6) Lower the main body of the extractor in to the cavity opening and in to position as per Fig.6 Fig.8...
-
Page 12: Guarantee
Guarantee Your new product is guaranteed against defect in materials and/ or workmanship. Any parts found to be defective will be repaired or replaced at our discretion. All repairs must be carried out by an authorised repair agent. Your extractor comes with a 5 year parts and 2 year labour guarantee. -
Page 13: Mains Electrical Connection
Mains electrical connection Warning! This appliance must be earthed. This appliance must be connected by a competent person, using fixed wiring via a double pole switched fused spur outlet, protected by a 3A fuse. DOUBLE POLE SWITCHED FUSED SPUR OUTLET We recommend that the appliance is connected by a qualified electrician, who is a member of the... -
Page 14: Energy Efficiency Information
Energy Efficiency Information Attribute Symbol Value Units Model Identification EDD62BL EDD92BL Annual Energy Consumption 55.45 55.45 Hood Time increase factor 1.12 1.12 24.3 24.3 Hood 63.6 63.6 Hood 296.16 296.16 Point 370.46 370.46 Point fl r i 549.1 549.1 Measured electric power at Best 125.23 125.23 Nominal lighting power... - Page 15 Notes Instruction Manual | 15...
- Page 16 The CDA Group Harby Road Langar Nottinghamshire NG13 9HY Sales Department Phone: 01949 862010 Email: sales@cda.eu CDA Customer Care Phone: 01949 862012 Email: customer.care@cda.eu ©2020 CDA Group Ltd...