Table of Contents
Advertisement
a)
Install all tire pressure sensors appropriately
b)
Pull up the parking brake
c)
Turn the ignition to ON/RUN with the engine off
d)
Enter the tire pressure learning mode through the instrument panel on vehicle. There will be the corresponding prompt,
which are differ from different car make and model, please subject to the vehicle manual or consult a professional)
e)
Starting from the left front wheel (some models flash the turn signal at the corresponding position), use the TPMS
Activation Tool to activate the sensor, and the vehicle will sound the horn or flash the turn signal at the corresponding
position after successful activation.
! Note: The first sensor should be learned within 2 minutes, otherwise please repeat step 4
f)
After the left front wheel sensor is successfully relearned. For the remaining, please activate the remaining tire pressure
sensors in the order of right front, right rear and left rear. The prompt and activation success status are the same as
step 5
! Note: The remaining sensor learning needs to be completed within 3 minutes, otherwise please repeat the relearn
procedure from step 4!
g)
Turn the vehicle off and power off. Adjust all sensors to the standard value.
h)
Tire pressure warning light will disappear after success. If procedure fails, please repeat steps 4-7
⚫
OBD RELEARN
1.
A TPMS Activation Tool is needed
2.
Install tire pressure sensor appropriately
3.
Adjust all TPMS sensors to the standard value
4.
Activate all sensors in the order of left front, right front, right rear, left rear
5.
Connect TPMS Activation Tool to the OBD port of vehicle and perform the OBD relearn function to write the sensor ID
6.
Turn the ignition to ON/RUN, re-trigger all sensors in the order of left front, right front, right rear, left rear
7.
Keep the vehicle powered off for more than 25 minutes
8.
Drive at 30-100km/h for more than 15 minutes. If relearn successful, the tire pressure warning light will go off. Otherwise,
please repeat steps 4-7
⚫
COPY ID RELEARN
! Note: This learning method of the vehicle can only copy ID to the new sensor through the following three methods
to replace the original sensor, if the new sensor cannot change its own ID, then the sensor can only be replaced by
the OEM equipment!
Method 1:
1.
Use a TPMS Activation Tool to activate the original sensor, copy the sensor ID to the tire pressure activation device
2.
And then program the copied ID into the new sensor through the TPMS Activation Tool (The binary of ID format should
be the same as the original sensor)
3.
Remove the original sensor that has been just copied the ID, install the new sensor that has just been programmed,
and put the tire back on
Method 2:
1.
Use the TPMS Activation Tool to connect the vehicle OBD port, enter the tire pressure system, copy the ID of the
sensor to be replaced
2.
And then program the copied ID into the new sensor through the TPMS Activation Tool (The binary of ID format should
be the same as the original sensor)
3.
Remove the original sensor that has been just copied the ID, install the new sensor that has just been programmed,
and put the tire back on
Method 3:
1.
Remove the original sensor
2.
Use the TPMS Activation Tool to copy the original sensor ID into the new sensor manually (The binary of ID format
should be the same as the original sensor)
31
Advertisement
Table of Contents
