Table of Contents
Advertisement
⚫
Tire replacement
⚫
After troubleshooting tire pressure related problems
⚫
Other causes of loss of signal from the tire pressure sensor
1. For tire pressure sensor matching, some vehicle models may need the TPMS activation tool;
2. After learning process, you may need to run the car for some while before the fault light goes off;
3. Tire pressure imbalance may also cause the tire pressure light;
4. This function is only available for activated tire pressure sensors. If you have a brand-new sensor, please use the professional
tire pressure device.
Even for the same model, its tire pressure system may differ by the region where it is manufactured. Therefore, under the
TPMS Reset function, we provide 6 menus for the major automotive manufacturing regions, including Korea, Japan, USA,
China, Australia and Europe, as shown below.
And then please enter the sub-menu by the origin region of car make and select the vehicle model you need
TPMS reset can be further divided into 4 methods, such as Automatic Relearn, Static Relearn, Copy ID and OBD Relearn,
which is depending on the specific model. Also, even if the relearning methods are the same, the learning procedure may
differ.
⚫
AUTOMATIC RELEARN
1.
Install tire pressure sensor appropriately
2.
Adjust all TPMS sensors to the standard value
3.
Keep the vehicle at a complete standstill status for more than 20 minutes (with the engine off and power off)
4.
Drive at 30-100km/h for more than 15 minutes
5.
The vehicle will automatically relearn the value, after that, the tire pressure warning will disappear
6.
If the relearn procedure fails, please repeat steps 2-5
⚫
STATIC RELEARN
30
Advertisement
Table of Contents
