QMS 2060 Setup Manual page 21

2 Turn on the printer (the power switch is on the left side).
The printer goes through an initialization warm-up and self-testing
that lasts less than 2 minutes. When the warm-up is complete,
Idle displays in the message window.
3 Turn on the PC.
4 A message window informs you New Hardware Found, and
then you're prompted to insert the printer driver disk.
5 Insert the QMS 2060 WX printer drivers disk or CD-ROM
(shipped with your printer) in the appropriate disk drive on
your PC, and choose OK to continue.
6 Follow the instructions on the screen to install the printer driver.
When the installation is complete, the Windows 95 desktop
appears.
7 Remove the disk or CD-ROM from the PC, and store it in a
safe place.
Because Ethernet connections don't support Plug and Play
technology, you must install the printer driver manually as follows.
Note: You can also use this procedure if you want to install the printer
»
driver manually on a Windows 95 PC attached to a printer via the
parallel port.
1 From the Windows 95 Start menu choose Settings.
2 From the Settings menu choose Printers.
3 Insert the QMS 2060 WX printer drivers disk or CD-ROM
(shipped with your printer) in the appropriate disk drive on
your PC.
4 Double-click on Add Printer.
5 Follow the instructions in the Add Printer Wizard.
6 When you're prompted to select a manufacturer and printer,
choose Have Disk...