Section 10
Reassembly
Install and Adjust Governor Lever
1. Install the governor lever* onto the governor
*NOTE: It is recommended that a new governor lever
be installed whenever removal is performed.
Figure 10-68. Governor Lever Installed on Shaft.
2. Move the governor lever toward the carburetor,
hold in this position. Do not apply excessive
counterclockwise as far as it will go. See Figure
(60-75 in. lb.).
Figure 10-69. Adjusting Governor and Linkage.
10.20
7.0-8.5 N·m
Rotate
Counter
Clockwise
Mounting Speed Control Bracket
in the original holes. If the holes were not marked
during disassembly, refer to the charts in
carburetor to the actuating lever of the speed
Choke Linkage
Figure 10-70. Connecting Choke Linkage and
Governor Spring.
mounting locations on the engine with the M6
screws. Position the bracket as marked during
disassembly. Torque the screws to 11.0 N·m
(95 in. lb.)
(65 in. lb.)
Figure 10-71. Attaching Speed Control Bracket.
Governor
Spring
7.5 N·m