Removing Speed Control Bracket From Closure Plate; Disconnecting Governor Spring; Removing Governor Lever; Removing Heat Deflector - Kohler Courage SV470 Service Manual

5. Mark the mounted position of the speed control
screws securing the speed control bracket to the
closure plate. Note or mark the governor spring
hole for correct installation later. Unhook the
governor spring, then remove the control bracket
Figure 8-16. Removing Speed Control Bracket
from Closure Plate.
Figure 8-17. Disconnecting Governor Spring.
*NOTE: It is recommended that a new governor lever
be installed whenever removal is performed.
Figure 8-18. Removing Governor Lever.
7. Remove the carburetor gasket, then carefully
the cylinder only if required.
Section 8
Disassembly
8
8.5